--extent

E

The extents that defines the window.

<LowerX> - A number specifying the lower left X origin in the coordinate reference system of the output.

<LowerY> - A number specifying the lower left Y origin in the coordinate reference system of the output.

<UpperX> - A number specifying the upper right X origin in the coordinate reference system of the output.

<UpperY> - A number specifying the upper right Y origin in the coordinate reference system of the output.

The unit is assumed to be that of the output's coordinate reference system, unless otherwise specified. When specifying units for un-projected data, an angle type unit is required. The order for un-projected coordinates is longitude followed by latitude. Supported units: cable, ch, cm, fm, ft, in, inm, km, m, mi, mm, nm, usfm, usft, usmi, usnm, usyd, yd, deg and rad.

--head-number

The transducer head number on which to execute the boresight estimation algorithm.

• ONE

• TWO

The default value is ONE.

FALSE

--max-patches

The maximum number of patches, which meet density and planarity criteria, to use for boresight computation.

The default value is 25, integer values greater than 1. Increasing this value will increase processing time, but may yield better results when the survey pattern is not optimal, e.g. slope less than 10 degrees.

FALSE

Default 25, values must be positive integers greater than 1.

--min-observability

Minimum observability criteria for each angle individually in a given patch to be considered in the boresight computation.

The default value is 0.

FALSE

Default 0, values must be positive, decimals allowed.

--update-vessel

Update the selected section of the HIPS Vessel File associated with the source data.

• TRANSDUCER

• SVP

If not set, the HVF is not updated.

FALSE

--report-file

If set, a report of the calibration results is output to the file name and path specified.

FALSE