Description
The ShiftHIPSNavigation process shifts the HIPS data track line navigation by the amount specified.
Update
One or more HIPS track lines.
Outputs
Updated HIPS track lines and project file.
Command Line Syntax
carisbatch --run ShiftHIPSNavigation --shift <value> [options] <update>
User Interface Command
Shift Navigation
Options
The following table describes the parameters available for this process.
Parameter |
| |||
|---|---|---|---|---|
Long | Short key | Description | Can Repeat | Notes |
--shift | Shift the navigation data in an X and Y direction, using the same units. (Longitude Latitude when geographic). <X_Longitude> - The X/Longitude shift. <Y_Latitude> - The Y/Latitude Shift. The offset has a maximum of 0.016667 in decimal degrees (geographic) or 1800 metres (ground). When specifying units for a geographic shift, an angle type unit is required. Supported units: cable, ch, cm, fm, ft, in, inm, km, m, mi, mm, nm, usfm, usft, usmi, usnm, usyd, yd, deg and rad. | FALSE | ||
Example
To use this command, refer to the following example.
Example | ||
|---|---|---|
Objective | To shift a selected track line by a specified amount. | |
Description | Command Line Syntax | |
The data will be shifted 0.001deg X and no shifted in Y direction. | --shift 0.001deg 0deg | |
The updated file is named input.hips and is located at C:\temp\input\. he HIPS file URI filters for the vessel named “sample” and the day 2000-001. | C:\temp\input\ | |
Command Line |
| |
Outcome | The selected track line or lines are shifted by the set amount. | |
Extra Notes | N/A | |